Audioscan Verifit 2 Manuel d'utilisateur télécharger pdf (Page 104)

Verifit

User's Guide Version 4.2 © June 2015

WARNING: Keep magnet out of reach of children and pets. If a magnet is swallowed seek immediate medical

attention.

ANSI S3.22 requires that the gain control be set to RTS before running this test. The reference test gain (RTG)

is required in order to calculate the or RSETS. The easiest way to meet both requirements is to run a [Linear] or

[AGC] test before running this test. See ANSI 2003 Linear and AGC tests. The tele-test handset comes with a

small magnet attached that may affect implantable devices. See How to Avoid Undesirable Side Effects.

1. First, complete an ANSI [Linear] or [AGC] test,

2. Click the right mouse button to raise the home menu, then select [Telecoil].

3. Set the aid to "T" (telecoil input).

4. Click [Start TMFS test]. Test setup instructions are displayed.

5. Position the aid on the 'T' on the tele-test handset. BTE aids should lie as flat as possible on the tele-test

surface, while custom aids should be oriented with their faceplate parallel to the top surface (if possible) and

touching it as shown.

6. Press to start the test.

7. While maintaining the orientation of step 5, move the hearing instrument around on the tele-test handset

surface to maximize the number shown in the [Maximize Average-SPLITS Value] box.

8. Without moving the hearing instrument, press to store the Average (HFA-or SPA) SPLITS value and

run the SPLITS curve.

If an RTG has been previously obtained, the RSETS will be shown.

ANSI test loop test

ANSI S3.22 requires that the gain control be set to RTS before running this test. The reference test gain (RTG)

is required in order to calculate the RTLS. The easiest way to meet both requirements is to run a [Linear] or

[AGC] test before running this test. See ANSI 2003 Linear and AGC tests

104

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 155 156

Pas de commentaire

Audioscan Verifit 2 Manuel d'utilisateur Page 104